The
New Car engine bracket is also a common product in life, but most of my friends don't know much about it.
The
Fuel Car engine bracket is a very common product with a wide range of applications. When using this product, we must know that the New Car engine bracket not only does not transmit vibration to the vehicle body, but also helps to improve the vehicle's maneuverability and steering feel.
In fact, the product mounting structure places a bracket on the front longitudinal beam, so that the upper end of the New Car engine cylinder block is kept on the right side of the vehicle and the transmission is kept on the left side of the power unit. shaft. Then you need to know that at these two points, the lower part of the block mainly swings back and forth, so the lower part is kept in the subframe position by the torque rod, away from the rotation axis.
Of course, this limits the swing like a pendulum. In addition, a torsion bar is added near the upper right bracket, which is fixed at four points. Only in this way can the position change of the Fuel Car engine due to acceleration and deceleration and left and right tilting be adjusted. The New Car engine bracket is more expensive than the three-point system, but it can better reduce shaking and idle vibration.
And in its lower half, anti-vibration rubber is built in instead of a metal block. This is the position where the weight of the Fuel Car engine enters from directly above, and is not only connected to the side beam, but also pulled out of the bracket and connected to a solid part inside the body.
